Water Heater Installation

Removed current tankless water heater unit and install customer provided. After killing the breakers and ensuring that the power was off, I removed the electrical and labeled it to install it properly. The water lines were cut, and the old unit was pulled off of the wall. The new unit was provided by the customer and (2) 3/4 Fip x crimp adaptors were attached with tape and dope. The unit was attached to the wall, and the water lines were crimped onto the unit. The electrical was installed. Ran hot water for 5 minutes through the sink and shower to ensure no air in the lines. The shower head was removed and cleaned due to debris not allowing it to flow. The head was reinstalled, and it has a good flow rate now. After the lines were air bled, the breakers were turned on. The water was hot as it should be and the unit was turned up to 130°F. The pipe insulation was taped back over the hot and cold lines to the water heater. A sticker was put on the heater and a magnet left inside the electrical panel.